Yamaha 2002 TDM900 Service Manual page 382

30
Fault code No.
Diagnostic monitoring
code No.
Order Item / components
1 The motorcycle has overturned.
2 Installed state of the lean angle cut-off
switch
3 Connected state of connector
Lean angle cut-off switch coupler
Main wiring harness ECU coupler
4 Defective lean angle cut-off switch
33
Fault code No.
Diagnostic monitoring
code No.
Order Item / components
1 Connected state of connector
Ignition coil primary side coupler
(Orange)
Main wiring harness ECU coupler
2 Open or short circuit in wiring harness
or sub lead.
3 Defective ignition coil
FUEL INJECTION SYSTEM
Symptom The motorcycle has overturned.
08 Lean angle cut-off switch
Check or maintenance job
Raise the motorcycle upright.
Check the installed area for looseness or
pinching.
Check the coupler for any pins that may have
pulled out.
Check the locking condition of the coupler.
If there is a malfunction, repair it and connect it
securely.
Execute the diagnostic monitoring mode.
(Code No. 08)
Replace if defective.
Symptom Malfunction detected in the primary wire of the ignition coil (#1).
30 Ignition coil (#1)
Check or maintenance job
Check the coupler for any pins that may have
pulled out.
Check the locking condition of the coupler.
If there is a malfunction, repair it and connect it
securely.
Repair or replace if there is an open or short
circuit.
Main wiring harness
Orange - Orange
Red / Black - Red / Black
Execute the diagnostic monitoring mode.
(Code No. 30)
Test the primary and secondary coils for
continuity.
Replace if defective.
Refer to "IGNITION SYSTEM" in chapter 8.
7-19
FI
Restore
method
Reinstated by
turning the i h
main switch
ON (however ON (however,
the engine
cannot be
restarted
unless the
main switch is
first turned
OFF).
Restore
method
Reinstated by
starting the
engine and
operating it at
idle.