Yamaha 2002 TDM900 Service Manual page 122

CHANGING THE ENGINE OIL
CAUTION:
The engine should be filled with oil in two
steps. First fill the engine with 3.0 liters of
oil. Then start the engine and race it five or
six time. Stop the engine and fill it with oil to
the specified level.
9. Install:
S engine oil filler cap
10. Start the engine, warm it up for several min-
utes, and then turn it off.
11. Check:
S engine
(for engine oil leaks)
12. Check:
S engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL".
13. Check:
S engine oil pressure
a. Slightly loosen the oil gallery bolt 1 .
b. Start the engine and keep it idling until en-
gine oil starts to seep from the oil gallery bolt.
If no engine oil comes out after one minute,
turn the engine off so that it will not seize.
c. Check the engine oil passages, the oil filter
and the oil pump for damage or leakage.
d. Start the engine after solving the problem (-s)
and check the engine oil pressure again.
e. Tighten the oil gallery bolt to specification.
3-33
CHK
ADJ
Quantity
Total amount
4.7 L
Without oil filter element
replacement
3.8 L
With oil filter element
replacement
3.9 L
Oil gallery bolt
10 Nm (1.0 mSkg)