Table of Contents
Advertisement
3.9.1
Job Settings
From the "job settings" menu the following settings
are available:
Envelope settings (see 3.9.2 "Envelope
Settings" on page 35)
Document settings (see 3.9.3 "Document
Settings" on page 36)
Fold settings (see 3.9.4 "Fold Settings" on
page 38)
Optical Mark Recognition (OMR) settings (if
installed) (see 3.9.5 "Optical Mark
Recognition Settings (Option)" on page 39)
Double feed control settings (see
3.9.6 "Double Feed Control Settings" on
page 42)
Job name settings (see 3.9.7 "Job Name" on
page 43)
Exit settings (see 3.9.8 "Exit Select
Settings" on page 43)
Mailing/Franking settings (if installed) (see
3.9.9 "Mailing/Franking Settings (Option)"
on page 44)
Mail Piece Production Control (MPPC)
settings (if installed)
See the appendix operator manual Mail
Piece Production Control
3.9.2
Envelope Settings
In this screen the properties of the used envelopes
must be entered. Also the sealing can be switched
on and off.
In the top of the screen, two selection buttons are
displayed, from which one can be selected. The
selected settings button will be highlighted yellow.
•
Press
to select an envelope size. Use the
upper
button to enter the applicable
dimensions.
It is also possible to select ISO standard envelopes or dimensions in inches (depends
on the installation settings).
The envelope height can be set between 90 mm (3.5 inch) and 162 mm (6.38 inch).
Use the second
for selecting exit settings (see 3.9.8 "Exit Select Settings" on page 43).
button to enter the envelope weight. Weight information is used
35
Advertisement
Table of Contents
