Subscribe to Our Youtube Channel
Related Manuals for Formax AutoSeal FD1500
Summary of Contents for Formax AutoSeal FD1500
- Page 1 FORMAX ® FD1500 AutoSeal ® OPERATOR MANUAL FIRST EDITION 1-800-543-5454 - www.officezone.com...
- Page 2 TABLE OF CONTENTS 1500 Shown with Optional Stand Page: DESCRIPTION, UNPACKING AND SET UP CONTROLS, OPERATION FOLD PLATE ADJUSTMENT, SETTING CUSTOM FOLDS DAILY MAINTENANCE / TROUBLE SHOOTING TROUBLESHOOTING 1-800-543-5454 - www.officezone.com...
- Page 3 DESCRIPTION Top Cover Upper Fold Plate Paper side guides In-feed table Control Panel Lower Fold Plate FUNCTION: The 1500 Folder / Sealer folds and seals many different configurations including, "C", "Z", “V” and custom folds. It may also use several different sizes of forms. For configurations and / or paper sizes see listing under specifications below.
- Page 4 CONTROLS Start…………………Starts machine. Stop…………………Stops machine. Ready light…………Steady green when power is on Blinks red when cover is open or fault is detected. Counter Reset..Resets counter if equipped. Counter…………….Shows forms count if so equipped. OPERATION 1. Adjust fold plates to desired fold for length of paper (see fold plate adjustment on page 3). To do this, loosen the two thumbscrews (figure 3a &...
- Page 5 FOLD PLATE ADJUSTMENT Upper Fold Plate Lower Fold Plate Thumbscrews (figure 3a) (figure 3b) 1. To adjust the first fold remove the top cover. If the first fold is too long loosen the two thumbscrews on the upper fold plate and slide the bar down. If the fold is too short loosen the thumbscrews and slide the bar up.
-
Page 6: Daily Maintenance
2. If toner builds up on the metal sealer rollers clean the rollers with a lint-free cloth dampened sparingly with a mild household cleaner. 3. Clean in-feed wheels and fold rollers with Formax recommended roller cleaner & rejuvenator to remove paper dust and toner. A damp cloth with water is the best alternative. CAUTION: Do not use any chemicals other than the roller cleaner &... - Page 7 B. Fold Quality Needs Improving 1. Make sure paper is squared and installed correctly. Side guides should be evenly balanced and snug against the paper. 2. If folds are still incorrect adjust fold plates (see fold plate adjustment on page 3). C.
Need help?
Do you have a question about the AutoSeal FD1500 and is the answer not in the manual?
Questions and answers