General; Start-Up Online Services - Formax 6602 Series Operator's Manual

Additional Marks
When it is required to control more functions in the
inserter system, the use of more marks is needed.
The following additional functions are possible via
software options:
• Divert mark (divert & continue)
• Stop mark (divert & stop)
• 1 mark: selective feed from station x (max. 6
depending on configuration)
• 1 mark: selective feed from (optional)
Thin Booklet Feeder
• Exit control mark
• Present on deck & continue mark
• Present on deck & stop mark
• Sealing control mark
• 1, 2 or 3 marks: respectively sequence check 4,
2 and 1
• 1 mark: parity check mark (even)
• 1 mark: safety mark (1-track OMR only)
General remarks:
• The marks must always be used in the above sequence.
• If a function is suppressed the following function will move upwards one line.
• The chosen code must always be used on all material which must be processed by the
Optical Mark Recognition.
• The length of the code and the mark definition is a service setting.
• Other marks/functions are possible via special codes (Flex codes).
Divert Mark (Divert & Continue)
The set will be diverted and the system continues.
Stop Mark (Divert & Stop)
The set will be diverted and the system stops indicating error VS:113 (stop mark read).
2-track OMR: the Divert and Stop mark are combined in one mark (see 4.2.5 "2-track
OMR" on page 56).
Selective Feed Mark
The machine will selectively feed an enclosure when commanded so.
52
Start mark
Insert/accumulate
Divert & continue
Divert & stop
Selective feed 1
Selective feed 2
Selective feed 3
Selective feed 4
Selective feed 5
Selective feed 6
Selective feed VersaFeeder
Exit control
Present on deck & continue
Present on deck & stop
Sealing control
Sequence check 4
Sequence check 2
Sequence check 1
Parity (even parity)
Safety mark