Table of Contents
Advertisement
4.4.3
Adjust Side Guides
Adjust the side guides:
1.
Take a stack of documents/BREs and place them
in the feed tray.
BREs with flap down and leading (top side
pointing to machine).
2.
Adjust the side guides by turning the thumb
wheel A so the documents/BREs just fit and can
move without resistance.
Too much play causes skewing.
4.4.4
Document Separation
When the Production Feeder is used at an automatic separation feeder, the separation is set
automatically.
The Production Feeder can also be used on a feeder position with a manually adjusted
separation.
To adjust, proceed as follows:
1.
Remove feeders 2 and 3.
Note
The lowest feeder is feeder 1.
2.
Squeeze the two blue handles A and B and shift
the feeding plate C as far as possible to the
front.
3.
Push knob D forward until it clicks.
4.
Place a document/BRE on the feed tray and slide
it in the machine till the leading edge is not
visible anymore. Turn knob D counterclockwise if
the separation is set to narrow.
5.
Push the document/BRE between the rollers.
6.
Turn knob D clockwise to get more resistance
and counterclockwise if the separation is set to
narrow.
The separation is adjusted correctly when a
slight resistance is felt on the document/BRE.
7.
Pull knob D back when ready.
8.
Remount feeders 2 and 3.
62
A
A
B
D
C
Advertisement
Table of Contents
