Table of Contents
Advertisement
Use the
button to switch automatic envelope sealing on, off or OMR (in case of
an OMR job, see "Sealing Control" on page 53).
•
Press
to set a job without inserting the documents in envelopes (no envelope
mode). This can be useful for jobs, where documents only have to be sorted and/or
folded.
Note
When no envelopes is selected the exit will be set to stacker.
Note
When no envelopes is selected the side guides of the stacker must be adjusted according
to the width of the used documents. Refer to the section 3.5.2 "Stacker Side Guides" on
page 27 and use a document instead of an envelope.
3.9.3
Document Settings
This screen enables the setting of the document
formats and the number of documents that must be
picked from the different feeders.
•
Press
to set the number of sheets for the
different feeders.
-
Press
Thin Booklet Feeder. The selected feeder
will be highlighted.
-
Press the arrows to change the number of
sheets that must be picked from the highlighted feeder. When the number of
documents is 0, the relevant feeder will be deselected.
Note
When a feeder is set to daily mail the number of documents is always 1 and can not be set
in this screen.
Note
The maximum number of sheets per feeder is 25. When folding is used the maximum set
thickness is 8 sheets in letter fold and 10 sheets (80 gr./m2) in single fold. When using
Folder and bottom address (see 3.9.4 "Fold Settings" on page 38) the number of sheets is
limited further.
•
Press
to enter the document height. The height or the ISO format of the
document will be displayed next to the relevant feeder.
-
Press
36
to select a feeder or the optional
to select a feeder. The selected feeder will be highlighted.
Advertisement
Table of Contents
