Step 4 Starting The Copy Job - Fuji Xerox ApeosPort-IV C5575 User Manual

3 Copy
2
If you have entered an incorrect value, press
the <C (Clear)> button and then enter the
correct value.

Step 4 Starting the Copy Job

The following describes how to start a copy job.
1
Press the <Start> button.
Important • If the document has been loaded in the
3
Note
If you have more documents
If you have more documents to copy, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to scan the documents as a single set of
data.
2
Select [Next Original] while scanning is in
progress.
Note
80
document feeder, do not hold down the
document while it is being conveyed.
• Copies cannot be made if a copy protection
code is detected. For information on a copy
protection code, refer to "Secure Watermark
(Managing Document Security)" (P.144).
• If a problem occurs, an error message
appears on the touch screen. Solve the
problem according to the message.
• You can set the next job during copying.
• When using the document feeder, load the
next document after the machine has
finished scanning the first document.
• When [Next Original] is displayed on the
screen shown on the right and no operation is
performed for a certain period of time, the
machine automatically assumes that there
are no more documents.
• You can change the number of copies by selecting [Change Quantity] that is displayed after
selecting [Delete].
<C (Clear)> button
<Start> button