Fujitsu N7100 Operator's Manual page 358

Table of Contents

Advertisement

When checking the network connection status by a Ping test, the following results are
possible.
Follow each action described below.
The four lines below are shown as a response from the ping test.
Reply from (destination IP address) :bytes=32 times<(time) ms
TTL=(TTL value)
■ Example of a response
Reply from XXX.XXX.XXX.XXX : bytes=32 time<1ms TTL=255
Reply from XXX.XXX.XXX.XXX : bytes=32 time<1ms TTL=255
Reply from XXX.XXX.XXX.XXX : bytes=32 time<1ms TTL=255
Reply from XXX.XXX.XXX.XXX : bytes=32 time<1ms TTL=255
■ Details
The response from the ping destination address is normal.
"Ping statistics" shows
"Lost=4 (100% loss)".
■ Details
 There is no response from the Ping target.
 There may be problems in the hardware transmission path. For example, the LAN cable may
have become disconnected during the ping test.
■ Action
 The specified Ping target might not be correct. Check that the Ping target IP address, host
name or FQDN is correct.
If the IP address that does not exist in the same segment is specified, "Lost=0 (0%loss)" is
shown. If an IP address that does not exist in a different segment is specified, "Lost=4
(100%loss)" is shown.
 The network transmission mode may differ from the connection target. In
Network Operating Status"
Negotiation" to a fixed mode.
 If the Ping target is correct and the network transmission method is appropriate, refer to
"Failure to Connect to a Server Using Its IP Address" (P.363)
 Check the status of the LAN cable or replace the LAN cable and try again.
 If a HUB device is used for connection, change the connection port of the LAN cable and try
again.
7.2 Network Connection Troubleshooting
(P.107), change [Link Speed/Duplex Mode] from "Auto-
358
"4.8.2 Checking the
for further solutions.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents