Version: 16.12.2014 - Porsche 2015 911 GT3 Cup Technical Manual

Insert the cross shaft in tool no. 44. Ensure the correct seat of the two insert
washers! The insert washers are supported by the cylinder rolls of the bearing (Figure
Powertrain
2.8.7.7)
2.8.7.7
Push the cage out of the cylinder roll bearing (cross shaft) with tool no. 44 (Figure
2.8.7.8)
2.8.7.8
Heat the cross shaft lid (1) at 130 °C (266 F) for 30 minutes
Take the outer ring of the cylinder roll bearing (2) out of the cross shaft lid (1)
(without applying great force)
2.8.7.9
911 GT3 Cup (991)

Version: 16.12.2014

68
MY 2015