Bodywork
4.15.1.3
4.15.1.4
911 GT3 Cup (991)
206
Heat the glued joint (2) with the heating gun and pry apart the sheet to the top using
a separating chisel.
Bore the marked rivets (1) only through the first sheet. Aluminum extruded sections
are in the carrier frame. The aluminum profile is behind the saw line (2). This cut
allows removing the front section, a more precise cut will follow in a later step.
Do not bore through the carrier frame. The carrier frame is not replaced now.
If the carrier is damaged behind the cutoff line (2), it is not possible to carry out the
repair work.
MY 2015
Version: 16.12.2014