Pressure/Retraction Clutch /1 (Cl4) - Konica Minolta bizhub C30P Service Manual

6. Other
[2]
[5]
6.3.32

Pressure/retraction clutch /1 (CL4)

1. Remove the driving unit assy.
See P.64
[1]
74
[1]
A011F2C078DA
[2]
[3]
[4]
[1]
A011F2C079DA
[3]
[2]
[3]
[1]
[4] [2]
A011F2C080DA
Field Service Ver. 2.0 May 2007
8. Remove three screws [1], and
remove the 2nd image transfer pres-
sure/retraction drive assy [2].
9. Snap off the C-clip [1], and remove
the bearing [2] and the pressure/
retraction clutch /2 [3].
NOTE
• When reinstalling the bearing and
pressure/retraction clutch /2, make
sure that the protrusion [4] on the
pressure/retraction clutch /2 fits
into the locking slot [5].
2. Remove three screws [1].
3. Snap off two E-rings [2], and remove
two bearings [3] and the pressure/
retraction clutch /1 assy [4].