Removing And Installing Sunlight Penetration Photosensor G107; Removing And Installing Temperature Sensor Blower V42; Removing And Installing Front Operating And Display Unit, Climatronic Control Unit J255 - Audi Air conditioning 2003 A8 Workshop Manual

Audi A8 2003 ➤
Air conditioning - Edition 09.2010
– Unplug the connector -A-.
– Give the vent temperature sender -B- an approx. 90° turn in
arrow direction.
– Pull the vent temperature sender out of the air duct.
Note
Depending on the design of the air duct, the sender may also be
installed at a different location in the duct.
8.5 Removing and installing sunlight pene‐
tration photosensor -G107-
– Switch off ignition.
– Carefully prise the cover -A- out of the windscreen defroster
vent
– Carefully prise the sunlight penetration photosensor -B- out of
the windscreen defroster vent.
– Detach the connector -C-.
Note
Different versions of the sunlight penetration photosensor -G107-
are available. Attention is therefore to be paid to correct assign‐
ment ⇒ Electronic parts catalogue .
8.6 Removing and installing temperature
sensor blower -V42-
– Remove the front operating and display unit, Climatronic con‐
trol unit -J255- ⇒ page 80
– Remove the bolts -A-.
– Pull the temperature sensor blower -V42- -B- out of the front
operating and display unit, Climatronic control unit -J255- .
Note
When installing the temperature sensor blower -V42- , do not
press on the motor -C- but rather hold the blower at the housing.
8.7 Removing and installing front operating
and display unit, Climatronic control unit
-J255-
– Removing and installing front operating and display unit, Cli‐
matronic control unit -J255-
80
Rep. gr.87 - Air conditioning system
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
⇒ page 82
with respect to the correctness of information in this document. Copyright by AUDI AG.