Dismantling And Assembling Air Distribution Housing - Audi Air conditioning 2003 A8 Workshop Manual

Audi A8 2003 ➤
Air conditioning - Edition 09.2010
15 - Evaporator output temperature sender -G263-
❑ Removing and installing
16 - Bottom left coolant pipe
17 - Top left coolant pipe
18 - Holder
19 - O-ring
❑ Replace
20 - Clamp
❑ Replace
❑ Ensure correct positioning
❑ If heat exchanger is replaced without removing, fit clamp instead of clip
21 - Left heat exchanger
❑ Removing and installing
❑ With seal to air conditioning unit housing
Note
22 - Right heat exchanger
❑ Removing and installing
❑ With seal to air conditioning unit housing (refer to note on left heat exchanger)
23 - Top right coolant pipe
24 - Bottom right coolant pipe
25 - Air distribution housing
❑ Dismantling and assembling
❑ Different versions for vehicles with and without rear Climatronic operating and display unit -E265-
15.3 Dismantling and assembling air distribu‐
tion housing
Note
The levers and cam plates are provided with code numbers.
♦
In cases of doubt about assignment of one of these compo‐
nents, pay attention to assignment.
Moisten the guides of the cam plates as well as the pins at the
♦
flap levers with a small quantity of e.g. lubricating paste -G 000
150- ⇒ Electronic parts catalogue .
188
Rep. gr.87 - Air conditioning system
⇒ page 107
⇒ page 116
⇒ page 112
⇒ page 188
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 112