Removing And Installing Right Footwell Flap Control Motor V109 - Audi Air conditioning 2003 A8 Workshop Manual

8.20 Removing and installing right footwell
flap control motor -V109-
Note
Mark the motor/flap connecting element on removal to avoid
♦
interchange with the connecting elements of other control mo‐
tors.
In the event of the fault „Upper or lower limit value exceeded",
♦
check the motor/flap connecting element. It must be properly
attached to the motor and there must not be any clearance
between the control motor mount and the connecting element.
Removing
– Switch off ignition.
– Remove the glove compartment. ⇒ General body repairs, in‐
terior; Rep. gr. 68
– Remove the centre console. ⇒ General body repairs, interior;
Rep. gr. 68
– Remove the right footwell vent (front passenger side).
– Carefully fold back the floor covering in the area of the control
motor.
– Screw out the bolts -A-.
– Mark the connector -B- to the control motor (to prevent inter‐
change with other identical connectors).
– Unplug the connector -B- from the control motor.
– Detach the control motor.
– Use 2 screwdrivers for example to carefully prise the cam plate
-C- off the control motor.
– Screw out the bolts -D-.
Installing
Install in reverse order, paying attention to the following.
– Attach the metal holder -E- to the control motor.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
8. Components for control and regulation of air conditioner located in passenger compartment
Air conditioning - Edition 09.2010
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A8 2003 ➤
103