Audi A8 2003 ➤
Air conditioning - Edition 09.2010
– Unplug the connector -A- from the high-pressure sender -
G65- .
– Screw out the bolts -B- and -C- (tightening torque 5 Nm).
– Take out the condenser downwards.
13.15.2 Installing
Install in reverse order.
13.16
Removing and installing restrictor
Note
This vehicle is only to be fitted with a red coloured restrictor
♦
(depending on the manufacturer, the colour may also tend to‐
wards orange) ⇒ Electronic parts catalogue ⇒ Air conditioner
with refrigerant R134a
♦
Differently coloured replacement restrictors are available
(„yellow" restrictor, diameter of bore/constriction 1.54 mm;
„red" restrictor, diameter of bore/constriction 1.42 mm). Atten‐
tion is therefore to be paid to assignment (different refrigerant
circuit matching).
There are different types of refrigerant line between the evap‐
♦
orator and compressor/reservoir depending on the vehicle
model. ⇒ Electronic parts catalogue
13.16.1 Removing
– Drain the refrigerant circuit: ⇒ Air conditioner with refrigerant
R134a
– Detach the refrigerant line at the screw connection -A- (seal
open connections).
– Use pointed-nose pliers to pull the restrictor -B- out of the re‐
frigerant line.
13.16.2 Installing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
Only fit restrictors of the same type. Restrictors of different colour
have different bore diameters: ⇒ Electronic parts catalogue
168
Rep. gr.87 - Air conditioning system