Audi Air conditioning 2003 A8 Workshop Manual page 158

Audi A8 2003 ➤
Air conditioning - Edition 09.2010
– Remove the holder for the vane pump -arrows-.
Note
To avoid damaging the air conditioner compressor and the refrig‐
erant lines/hoses, make sure the lines and hoses are not strained,
kinked or bent.
– Detach the refrigerant lines from the air conditioner compres‐
sor -arrows- ⇒ page 138
– Seal the openings in the air conditioner compressor.
– Unplug the connector -1-.
– Screw out the bolts -arrows- and detach the air conditioner
compressor.
13.5.2 Installing
Install in reverse order, paying attention to the following:
Note
Heed the notes on removal and installation as well as com‐
♦
missioning of the compressor
Replace oil seals and O-rings.
♦
Pay attention to dowel sleeves.
♦
Secure all hose connections with standard clamps ⇒ Elec‐
♦
tronic parts catalogue .
– Install the vane pump ⇒ Running gear, front-wheel drive and
four-wheel drive; Rep. gr. 48 .
– Fit the poly V-belt ⇒ 12-cyl. engine, mechanics; Rep. gr. 13 .
– Install the lock carrier with attachments ⇒ General body re‐
pairs, exterior; Rep. gr. 50 .
152
Rep. gr.87 - Air conditioning system
.
⇒ page 140 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.