Removing And Installing Air Flow Flap Control Motor V71 With Potentiometer G113; Permitted Unless Authorised By Audi Ag. Audi Ag Does Not Guarantee Or Accept Any Liability - Audi Air conditioning 2003 A8 Workshop Manual

5.11 Removing and installing air flow flap
control motor -V71- with potentiometer -
G113-
Note
Mark the motor/flap connecting element on removal to avoid
♦
interchange with the connecting elements of other control mo‐
tors.
In the event of the fault „Upper or lower limit value exceeded",
♦
check the motor/flap connecting element. It must be properly
attached to the motor and there must not be any clearance
between the control motor mount and the connecting element.
– Remove the intake housing with air flow flap
5.11.1 Removing
– Screw out the bolts -A-.
– Take the socket -C- out of the mount.
– Detach the control motor.
– Unplug the connector -B- from the control motor.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not

permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability

with respect to the correctness of information in this document. Copyright by AUDI AG.
5. Components for control and regulation of air conditioner not located in passenger compartment
Air conditioning - Edition 09.2010
⇒ page 42 .
Audi A8 2003 ➤
45