Removing And Installing Left Centre Vent Control Motor V110 - Audi Air conditioning 2003 A8 Workshop Manual

Audi A8 2003 ➤
Air conditioning - Edition 09.2010
8.2 Removing and installing left centre vent
control motor -V110-
Note
Mark the motor/flap connecting element on removal to avoid
♦
interchange with the connecting elements of other control mo‐
tors.
In the event of the fault „Upper or lower limit value exceeded",
♦
check the motor/flap connecting element. It must be properly
attached to the motor and there must not be any clearance
between the control motor mount and the connecting element.
In the event of „clicking noise" from the area of the control mo‐
♦
tor, check the connection of the lug of the connecting element
at the control motor to the vent adjustment levers. Such noise
may be produced if the lug does not engage properly between
the two adjustment levers.
8.2.1 Removing
– Remove the storage compartment beneath the dash panel on
the left ⇒ General body repairs, interior; Rep. gr. 70 .
– Switch on ignition.
– Set the air distribution at the front operating and display unit,
Climatronic control unit -J255- to dash panel vents and open
the two dash panel vents -A- and -B-.
– Pull the left centre dash panel vent -A- out of the dash panel
⇒ General body repairs, interior; Rep. gr. 70 .
– Close the left -A- and right -B- centre dash panel vents by way
of the corresponding knurled wheels.
– Set the air distribution to footwell on the front operating and
display unit, Climatronic control unit -J255- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
76
Rep. gr.87 - Air conditioning system