Removing And Installing Rear Left Vent Control Motor V218 And Rear Right Vent Control Motor V219 - Audi Air conditioning 2003 A8 Workshop Manual

Audi A8 2003 ➤
Air conditioning - Edition 09.2010
8.25 Removing and installing rear left vent
control motor -V218- and rear right vent
control motor -V219-
Note
Mark the motor/flap connecting element on removal to avoid
♦
interchange with the connecting elements of other control mo‐
tors.
In the event of the fault „Upper or lower limit value exceeded",
♦
check the motor/flap connecting element. It must be properly
attached to the motor and there must not be any clearance
between the control motor mount and the connecting element.
These control motors are only fitted on vehicles with rear Cli‐
♦
matronic operating and display unit -E265- . Vehicles with no
rear Climatronic operating and display unit -E265- have no
flaps fitted at this location in the air duct of the air conditioning
unit.
In cases of doubt about correct connector assignment after
♦
fitting the control motors, unplug the connector from one con‐
trol motor for example and then interrogate the fault memory
of the rear Climatronic operating and display unit -E265- ⇒
"Guided fault-finding" function of vehicle diagnostic, testing
and information system VAS 5051.
Removing
– Switch off ignition.
– Remove the centre console. ⇒ General body repairs, interior;
Rep. gr. 68
– Mark the connector -B- to the rear left vent control motor -
V218- and -C- to the rear right vent control motor -V219- to
prevent possible interchange on account of identical connec‐
tors.
– Screw out the bolts -A-.
– Unplug the connectors -B- and -C- from the control motors.
– Detach the holder -D- with both control motors.
108
Rep. gr.87 - Air conditioning system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.