Removing And Installing Front Left Defroster And Chest Vent Shut-Off Flap Control Motor V200 - Audi Air conditioning 2003 A8 Workshop Manual

8.17 Removing and installing front left de‐
froster and chest vent shut-off flap con‐
trol motor -V200-
Note
Mark the motor/flap connecting element on removal to avoid
♦
interchange with the connecting elements of other control mo‐
tors.
In the event of the fault „Upper or lower limit value exceeded",
♦
check the motor/flap connecting element. It must be properly
attached to the motor and there must not be any clearance
between the control motor mount and the connecting element.
Removing
– Switch off ignition.
– Remove the centre console. ⇒ General body repairs, interior;
Rep. gr. 68
– Remove the storage compartment beneath the dash panel on
the left and the steering column support to the transmission
tunnel. ⇒ General body repairs, interior; Rep. gr. 68
– Screw out the bolts -A-.
– Mark the connector -B- to the control motor (to prevent inter‐
change with other identical connectors).
– Unplug the connector -B- from the control motor.
– Detach the control motor.
– Use 2 screwdrivers for example to carefully prise the cam plate
-C- off the control motor.
– Screw out the bolts -D-.
Installing
– Attach the metal holder to the control motor.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
8. Components for control and regulation of air conditioner located in passenger compartment
Air conditioning - Edition 09.2010
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A8 2003 ➤
97