Preparing Adapter Cables For Control Motor Actuation; With Respect To The Correctness Of Information In This Document. Copyright By Audi Ag; Removing And Installing Fresh Air Intake Duct Temperature Sensor G89; Removing And Installing Air Recirculation Flap Control Motor V113 - Audi Air conditioning 2003 A8 Workshop Manual

5.12 Preparing adapter cables for control mo‐
tor actuation
– Make connection to contacts „5" and „6" of connector -A- (part
number 6Q0 972 706) using wire with a cross section of 0.25
2
mm in each case. ⇒ Electronic parts catalogue
– Connect the other end of each wire to a commercially available
banana plug -B-.
5.13 Removing and installing fresh air intake
duct temperature sensor -G89-
– Remove the plenum chamber cover on the left and right.
– Remove the dust and pollen filter
– Detach the temperature sensor -A- from the intake housing
-B-.
5.14 Removing and installing air recirculation
flap control motor -V113-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability

with respect to the correctness of information in this document. Copyright by AUDI AG.

⇒ page 31
5. Components for control and regulation of air conditioner not located in passenger compartment
Air conditioning - Edition 09.2010
.
Audi A8 2003 ➤
47