Protected By Copyright. Copying For Private Or Commercial Purposes, In Part Or In Whole, Is Not; Removing And Installing Evaporator Output Temperature Sender G263 - Audi Air conditioning 2003 A8 Workshop Manual

– Unplug the connector -A- from the temperature sensor.
– Turn the temperature sensor -1- through approx. 90° in arrow
direction.
– Take the temperature sensor out of the air conditioning unit.
Installing
– Install in reverse order.
8.23 Removing and installing right vent tem‐
perature sender -G151-
Removing
– Switch off ignition.
– Remove the glove compartment. ⇒ General body repairs, in‐
terior; Rep. gr. 70
– Remove the right footwell vent (front passenger side).
– Unplug the connector -A- from the temperature sensor.
– Turn the temperature sensor -1- through approx. 90° in arrow
direction.
– Take the temperature sensor out of the air conditioning unit.
Installing
– Install in reverse order.
8.24 Removing and installing evaporator out‐
put temperature sender -G263-
Removing
– Switch off ignition.
– Remove the glove compartment ⇒ General body repairs, in‐
terior; Rep. gr. 68 .
– Remove the right footwell vent (front passenger side).
– Unplug the connector -A- from the sender.
– Turn the sender -1- through approx. 90° in arrow direction.
– Take the temperature sensor out of the air conditioning unit.
Installing
– Install in reverse order.
8. Components for control and regulation of air conditioner located in passenger compartment
Air conditioning - Edition 09.2010

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not

permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A8 2003 ➤
107