Table 10 Switch Setup - ZyXEL Communications GS-3012F User Manual

GS-3012/GS-3012F User's Guide
The following table describes the labels in this screen.

Table 10 Switch Setup

LABEL
VLAN Type
Bridge Control
Protocol
Transparency
MAC Address
Learning
Aging Time
GARP Timer
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using
GARP. Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all
registrations. GARP timers set declaration timeout values. See the chapter on VLAN setup for more
background information.
Join Timer
Leave Timer
Leave All Timer Leave All Timer sets the duration of the Leave All Period timer for GVRP in
Priority Queue Assignment IEEE 802.1p defines up to eight separate traffic types by inserting a tag into
a MAC-layer frame that contains bits to define class of service. Frames without an explicit priority tag
are given the default priority of the ingress port. Use the next two fields to configure the priority level-to-
physical queue mapping.
The switch has eight physical queues that you can map to the eight priority levels. On the switch, traffic
assigned to higher index queues gets through faster while traffic in lower index queues is dropped if the
network is congested.
See also Queuing Method and 802.1p Priority in Port Setup for related information.
Priority Level (The following descriptions are based on the traffic types defined in the IEEE 802.1d
standard (which incorporates the 802.1p).
Level 7
Level 6
Level 5
Level 4
Level 3
Level 2
Level 1
65
DESCRIPTION
Choose 802.1Q or Port Based. The VLAN Setup screen changes depending on
whether you choose 802.1Q VLAN Type or Port Based VLAN Type in this screen.
See Section 6.4 on page 64
Select Active to allow the switch to handle bridging control protocols (STP for
example). You also need to define how to treat a BPDU in the Port Setup screen.
MAC address learning reduces outgoing traffic broadcasts. For MAC address learning
to occur on a port, the port must be active.
Enter a time from 10 to 3000 seconds. This is how long all dynamically learned MAC
addresses remain in the MAC address table before they age out (and must be
relearned).
Join Timer sets the duration of the Join Period timer for GVRP in milliseconds. Each
port has a Join Period timer. The allowed Join Time range is between 100 and 65535
milliseconds; the default is 200 milliseconds. See the chapter on VLAN setup for more
background information.
Leave Timer sets the duration of the Leave Period timer for GVRP in milliseconds.
Each port has a single Leave Period timer. Leave Time must be two times larger than
Join Timer. The default is 600 milliseconds.
milliseconds. Each port has a single Leave All Period timer. Leave All Timer must be
larger than Leave Timer. The default is 10000 milliseconds.
Typically used for network control traffic such as router configuration messages.
Typically used for voice traffic that is especially sensitive to jitter (jitter is the variations
in delay).
Typically used for video that consumes high bandwidth and is sensitive to jitter.
Typically used for controlled load, latency-sensitive traffic such as SNA (Systems
Network Architecture) transactions.
Typically used for "excellent effort" or better than best effort and would include
important business traffic that can tolerate some delay.
This is for "spare bandwidth".
This is typically used for non-critical "background" traffic such as bulk transfers that
are allowed but that should not affect other applications and users.
and the chapter on VLAN for more information on VLANs.
Chapter 6 Basic Setting