Command Line Ftp; Filename Conventions; Example Ftp Commands; Figure 96 Confirm Restart The Switch - ZyXEL Communications GS-3012F User Manual

GS-3012/GS-3012F User's Guide

Figure 96 Confirm Restart the Switch

Click OK and then wait for the switch to finish rebooting before you attempt to access the
switch again. This takes up to two minutes. This does not affect the switch's configuration.

24.7 Command Line FTP

This section shows some examples of uploading to or downloading files from the switch using
FTP commands. First, understand the filename conventions.

24.7.1 Filename Conventions

The configuration file (often called the romfile or rom-0) contains the factory default settings
in the screens such as password, switch setup, IP setup, etc. Once you have customized the
switch's settings, they can be saved back to your computer under a filename of your choosing.
Note: A configuration file that you save from your switch to your computer does not
include the password, the error log or the trace log.
When you restore a backup configuration file from your computer to your
switch, does not change the password, the error log or the trace log.
ZyNOS (ZyXEL Network Operating System sometimes referred to as the "ras" file) is the
system firmware and has a "bin" filename extension.

Table 60 Filename Conventions

FILE TYPE
Configuration
File
Firmware

24.7.1.1 Example FTP Commands

ftp> put firmware.bin ras
149
INTERNAL EXTERNAL
NAME NAME
config
ras *.bin
DESCRIPTION
This is the configuration filename on the switch.
Uploading the config file replaces the specified
configuration file system, including your switch
configurations and system-related data.
This is the generic name for the ZyNOS firmware on the
switch.
Chapter 24 Maintenance