GS-3012/GS-3012F User's Guide
Figure 157 no vlan Command Example
ras(config)# no vlan 2
32.6 Enable VLAN
Syntax:
This command enables the specified VLAN ID in the SVLAN (Static VLAN) table.
32.7 Disable VLAN
Syntax:
This command disables the specified VLAN ID in the SVLAN (Static VLAN) table.
32.8 Show VLAN Setting
Syntax:
This command shows the IEEE 802.1Q Tagged SVLAN (Static VLAN) table.
An example is shown next.
For the
AdCtl
and "F" is a fixed port.
For the
TagCtl
219
vlan <vlan-id>
vlan <vlan-id> inactive
show vlan
section of the last column, "-" is a port set to normal, "x" is a forbidden port
section of the last column, "T" is a tagged port, "U" is an untagged port.
Chapter 32 IEEE 802.1Q Tagged VLAN Commands