Interface; Bpdu-Control; Figure 135 Interface Command Example - ZyXEL Communications GS-3012F User Manual

31.8.1 interface

Syntax:
Each interface refers to an Ethernet port on the switch. Commands configured after the
interface command correspond to those ports. Type multiple ports or port ranges separated by
a comma. Ranges of port numbers are typed separated by a dash.
An example is shown next.
• Enter the configuration command set.
• Enable ports one, three, four and five for configuration.
• Begin configuring for those ports.

Figure 135 interface Command Example

ras# config
ras(config)# interface port-channel 1,3-5
ras(config-interface)#

31.8.2 bpdu-control

Syntax:
where
<peer|tunnel|d
iscard|network
>=
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the BPDU control to tunnel, to forward BPDUs received on ports one, three, four and
five.
Chapter 31 Command Examples
interface
bpdu-control <peer|tunnel|discard|network>
Type
peer
Type
tunnel
Type
discard
Type
network
forward a tagged BPDU.
GS-3012/GS-3012F User's Guide
to process any BPDUs received on these ports.
to forward BPDUs received on these ports.
to drop any BPDUs received on these ports.
to process a BPDU with no VLAN tag and
204