Mounting The Engine - Seagull Models TWIN COMANCHE SEA134 Assembly Manual

TWIN COMANCHE

MOUNTING THE ENGINE.

+ ENGINE .46- .55 : 2 STROKE.
1) Connect the Z-bend in the 450mm throttle
pushrod to the outer hole of the carburetor arm.
2) Slide the throttle pushrod wire into the tube.
Position the engine between the mounts. Use
four M3x25mm machine screws to secure the
engine to the mount as shown.
Machine screw M3x25mm.
3) Reinstall the servo horn by sliding the
connector over the pushrod wire. Center the
throttle stick and trim and install the servo horn
perpendicular to the servo center line.
4) Move the throttle stick to the closed position
and move the carburetor to closed. Use a 2.5mm
hex wrench to tighten the screw that secures
the throttle pushrod wire. Make sure to use
threadlock on the screw so it does not vibrate
loose.
18
Pushrod wire.
gine and line up the back edge of the cowl with
the marks you made on the fuselage then trim
and cut as shown.
Instruction Manual.
COWLING.
Epoxy.
1) Slide the fiberglass cowl over the en-
Epoxy.
Trim and cut.