2) Use a pin drill and 2mm drill bit to drill a
small indentation in the mount for the engine
mounting screw.
3) Use a drill to drill the four holes in the engine
mount rails.
Knife.
www.seagullmodels.com
2mm.
2mm.
Epoxy.
+ ENGINE .72- .82 : 4 STROKE.
1) Position the engine with the drive washer
(118mm) forward of the firewall as shown.
118mm.
2) Use a pin drill and 2mm drill bit to drill a
small indentation in the mount for the engine
mounting screw.
Epoxy.
Epoxy.
2mm.
15