Installing The Main Landing Gear; Mounting The Engine - Seagull Models SEA158 Assembly Manual

6) Slide the threaded end of the axle
through the hole in the bottom of the landing
gear leg. Use a washer and locknut to tighten
the axle to the landing gear. Make sure to use
threadlock on the nut so it won't vibrate loose
in flight as shown.
Landing Gear.
C/A glue.
7) Tighten the setcrews using a hex
wrench to secure the collars on the axle over
the flat spot to retain the wheel as shown.
Locker glue.
wheel Pant.
Repeat steps as above to attach remain-
ing wheel pants to the landing gear.

INSTALLING THE MAIN LANDING GEAR.

1) The blind nuts for securing the landing
gear are already mounted inside the fuselage.
2) Using the hardware provided, mount the
main landing gear to the fuselage.
4x20 mm.

MOUNTING THE ENGINE.

1) Position the engine with the drive washer
(145mm) forward of the firewall as shown.
145mm.
2) Use a pin drill and 4mm drill bit to drill a
small indentation in the mount for the engine
mounting screw.
9