Table of Contents
Advertisement
Available languages
Available languages
Only a qualified agency should install and
replace gas piping, gas utilization equipment
or accessories, and repair and equipment ser-
vicing. The term "qualified agency" means any
individual, firm, corporation, or company that
either in person or through a representative
is engaged in and is responsible for:
SAFETY PILOT
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot shuts off the heater if there is not
enough fresh air.
2 GAS OPTIONS AVAILABLE
Your heater is equipped to operate on either
Propane/LP or Natural gas. The heater is
shipped from the factory ready for connect-
ing to Propane/LP. The heater can easily be
changed to Natural gas by having your quali-
fied installer follow the instructions on page
14 and the markings on the heater.
Install and use heater with care. Follow all
local codes. In the absence of local codes,
use the latest edition of The National Fuel
Gas Code, ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
1 Batterymarch Park
Quincy, MA 02269-9101
6
QUALIFIED INSTALLING AGENCY
PRODUCT FEATURES
LOCAL CODES
www.usaprocom.com
a) Installing, testing, or replacing gas piping
or
b) Connecting, installing, testing, repairing,
or servicing equipment; that is experienced
in such work; that is familiar with all precau-
tions required; and that has complied with
all the requirement of the authority having
jurisdiction.
PIEZO IGNITION SYSTEM
This heater is equipped with a piezo ignitor.
this system requires no matches, batteries, or
other sources to light heater.
THERMOSTATIC CONTROL
(Thermostat Models Only)
These heaters have a control valve with a
thermostat sensing bulb. This results in the
greatest heater comfort and may result in
lower gas bills.
State of Massachusetts: The installation
must be made by a licensed plumber or
gas fitter in the Commonwealth of Mas-
sachusetts.
Sellers of unvented propane or natural
gas-fired supplemental room heaters shall
provide to each purchaser a copy of 527
CMR 30 upon sale of the unit.
In the State of Massachusetts the gas
cock must be a T-handle type. The State
of Massachusetts requires that a flexible
appliance connector cannot exceed three
feet in length.
200218-01A
- Quick Links:
- Installation
- Troubleshooting
- Replacement Parts
- Parts
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the MNSD2TPA and is the answer not in the manual?
Questions and answers
Propane gas assembly specs and setup Instructions
The ProCom MNSD2TPA heater operates with propane gas and has the following specifications:
- BTU Output: 10,000 BTU
- Regulator Pressure Setting: 10 inches of water column (c.a.)
- Gas Inlet Pressure:
- Maximum: 14 inches of water column (c.a.)
- Minimum: 11 inches of water column (c.a.)
- Ignition Type: Piezoelectric
For setup and installation:
- Ensure the heater is equipped for propane gas use.
- Follow the installation instructions in the manual.
- Do not attempt field conversion between gas types.
- Installation and service must be performed by a qualified installer, service agency, or gas supplier.
- Follow safety precautions, including avoiding the use of flammable vapors near the unit.
This answer is automatically generated