Table of Contents
Advertisement
Available languages
Available languages
When Gas Pressure Is Too Low
• pilot will not stay lit
• burners will have delayed ignition
• fireplace will not produce specified heat
You may have further questions about installation, operation, or troubleshooting. If so, contact
ProCom Heating, Inc. at 1-866-573-0674.
When calling, please have your model and serial numbers of your heater ready.
200218-01A
SERVICE HINTS
• propane/LP gas supply might be low (pro-
You may feel your gas pressure is too low. If
so, contact your local gas supplier.
TECHNICAL SERVICE
www.usaprocom.com
pane/LP units only)
29
- Quick Links:
- Installation
- Troubleshooting
- Replacement Parts
- Parts
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the MNSD2TPA and is the answer not in the manual?
Questions and answers
Propane gas assembly specs and setup Instructions
The ProCom MNSD2TPA heater operates with propane gas and has the following specifications:
- BTU Output: 10,000 BTU
- Regulator Pressure Setting: 10 inches of water column (c.a.)
- Gas Inlet Pressure:
- Maximum: 14 inches of water column (c.a.)
- Minimum: 11 inches of water column (c.a.)
- Ignition Type: Piezoelectric
For setup and installation:
- Ensure the heater is equipped for propane gas use.
- Follow the installation instructions in the manual.
- Do not attempt field conversion between gas types.
- Installation and service must be performed by a qualified installer, service agency, or gas supplier.
- Follow safety precautions, including avoiding the use of flammable vapors near the unit.
This answer is automatically generated