Field Service Ver. 1.0 Apr. 2008
B. Reinstallation procedure
1. Remove the shipping tape affixed on the new PH unit shield sheet.
[1]
[1]
[2]
[1]
2. Unfold the rectangular area of the
shield sheet [1] so that the part is
lying flat.
A011F2C050DA
3. Insert the PH unit connector [1] and
flat cable [2] from the positions
shown in the left illustration.
Then route them to the rear direc-
tion.
A011F2C051DA
4. Install the PH unit [1] into the main
body.
NOTE
• After the PH unit installation, check
that the shield sheet is grounded
properly onto the base of the PH
unit.
• Make sure that the shield sheet
does not have any unnecessary
crease, positional misalignment nor
loose attachment.
A011F2C052DB
6. Other
67