Table of Contents
Advertisement
Remote-programmable Call Forwarding
74 Remote-programmable Call Forwarding
Least Cost Routing (LCR) is used with remote dialling, provided
the system administrator has correspondingly configured LCR
and its application in the Comfort Pro S/T-Comfort 930 DSL.
Ask your administrator for the configuration applicable to you.
Configuring the function
Z
(reserved tel. no.)
Z
(your internal tel. no.)
(trunk line seizure code, e.g.
Z
(destination tel. no.)
Deleting the function
Z
(reserved tel. no.)
Z
(your internal tel. no.)
Using the telephone number reserved in the Comfort Pro S/
T-Comfort 930 DSL for remote control, you can configure
or delete call forwarding "Immediate" for your own telephone
number from a remote location. This remotely-programmed for-
warding overwrites any other existing call forwarding. Call for-
warding "On Busy" and "After Delay" are not affected. Incorrect
or non-existent telephone numbers are rejected. Your authorisa-
tion is checked in the same way as for forwarding within the
Comfort Pro S/T-Comfort 930 DSL.
A correct entry is confirmed with a positive acknowledgement
signal, provided the system administrator has not deactivated
this function (in the Configurator, PBX Configuration: System:
Settings menu). The external call is subsequently ended.
Note:
The procedure is aborted if there is a pause of longer than
60 seconds between the entry of two digits. With this dura-
tion, remote-controlled functions using GSM cell phones
can also be realised.
Z
(system PIN)
)
Z
(system PIN)
Remote-controlled Functions
Advertisement
Table of Contents
