Telephone; Ending Calls - Telekom T-Comfort 630 User Manual

Busy Display for Bundles and Routes on the System Telephone

Ending Calls

Making Calls
For information on the current routes and their codes, please
contact your system administrator.
The system telephones can display whether all lines of a bundle
(trunk group) or a route are busy.
To do this, you must program a function key for the system tele-
phone in the Configurator (in the PBX Configuration: Devices:
System phones menu, function "Bundle state" or "Route
state"). This function cannot be programmed on the system tele-
phone itself. Contact your system administrator if necessary so
that this key can be configured for you.
The name of the bundle or route and the number of busy chan-
nels appear in the display. This display is constantly refreshed.
If the "Route state" function is programmed and you press this
key briefly, the routing code will be dialled accordingly (e.g. "0").
If all lines in the bundle or the route are busy, the LED on the
programmed function key is illuminated.
Calls are ended by replacing the handset or pressing the dis-
connect key or, in hands-free mode, by pressing the
hands-free key
you can only replace the handset. If the subscriber you are
speaking to ends the call while you are in hands-free mode, the
busy tone for your telephone is switched off after a few seconds
and you can be reached again. This also applies if you were
connected to the other subscriber via your headset. The time
frame after which the busy tone is switched off is configured by
the system administrator. All other calls will be ended after
20 seconds if the handset is off-hook.
. On the T-Comfort 630 Systemtelefon
Making External/Internal Calls 45