Table of Contents
Advertisement
Programming the Call Keys
MenuCard "Prog. call key" (Trunk Key)
Team Functions
The call keys are configured in the Configurator on the
Comfort Pro S/T-Comfort 930 DSL Web console. For system
telephones, you can configure the following:
the type of key (trunk key, team key, busy key or direct-call
■
key),
the telephone number and the text currently assigned to the
■
key,
the call-signalling mode for this key.
■
You can change the pre-settings for the text and the call signal-
ling mode on the appropriate key's MenuCard (see the follow-
ing sections: MenuCard "Prog. call key" (Trunk Key) on
page 69, MenuCard "Prog. team key" on page 71, and Menu-
Card "Prog. busy key" on page 72) as well as most of the set-
tings for supported features.
If the configuration of a call key is changed in the Configurator,
the telephone will load the new settings and not be operational
for a few moments. For more information on the configuration,
refer to the online help of the Comfort Pro S/
T-Comfort 930 DSL.
Press and hold down the trunk key
select ...
1ƒModify text
: You will see the text currently assigned to
the key. This text is displayed on the display of your telephone.
To change the text, press
the
key and enter new text, if required. Press
Save
confirm this with
number will be displayed.
2ƒCall diversion
call forwarding for the trunk key (
delay
Busy
,
). Proceed as with programming the "Divert
phone" function (see the section entitled MenuCard
for a moment, then
. Delete the existing text with
. If you delete the text, only the key's call
: You can configure one or more types of
Immediately
Programming the Call Keys 69
and
After
,
Advertisement
Table of Contents
