5. Insert the pushrod in the outer pushrod tube.
6. Remove the steering arm and insert the Z-bend into
the outer hole. Re-attach the steering arm.
7. Bend the end of the pushrod so that it aligns with the
pushrod connector.
8. Remove the rudder servo arm, insert the steering
pushrod in the pushrod connector and reinstall the servo arm.
9. Center the nose wheel and tighten the screw.
Electric Motor Installation
Proceed to Engine and Tank Installation (page 23) if a
gas engine will be installed.
1. Use epoxy to glue the front, back, top, bottom and side
plates of the motor box together.
21