GREAT PLANES Avistar 30cc ARF Instruction Manual page 16

4. Slide the tail gear spacer and the tail gear wire support
onto the tail gear wire.
5. Test fit the tail gear wire assembly in the tail gear bearing.
6. Position the tail gear bracket over the tail gear spacer.
On the bottom of the fuselage, mark the two mounting hole
locations.
7. Drill a 1/16" (1.5 mm) hole at each mark.
8. Apply 6-minute epoxy in the hole for the tail gear wire
support. Before the epoxy cures, insert the support in the
hole and the tail gear wire in the tail gear bearing. Attach the
tail gear bracket to the fuselage with two #2 x 3/8" (9.5mm)
sheet metal screws.
9. Install and tighten the 3mm set screw in the tail gear
spacer. Check that the rudder and tail gear move smoothly.
10. Install the tail wheel.
16