Install The Main Landing Gear - GREAT PLANES Avistar 30cc ARF Instruction Manual

A = B
A
5. Check the alignment of the horizontal stabilizer. The
distance from the center of the nose of the fuselage to the
tips of the horizontal stabilizer should be equal.
6. The wing and the stabilizer should be parallel. If they
are not, lightly sand the stabilizer slot.
7. Use 30-minute epoxy to glue the stabilizer and fin in
the fuselage. Clean off any excess epoxy with denatured
epoxy and paper towels.
B
14

Install the Main Landing Gear

If installing the optional fl oats (GPMA1676), skip to
Install the Rudder & Elevator Servos
1. Install the 3/16" [4.8mm] axles.
2. Cut the axle to length.
3. File a fl at spot at the bottom end of the axle.