Table of Contents
Advertisement
❏
10. From the LE of the rudder measure back 2" [51mm]
and make a mark. Drill a 5/32" [4mm] hole into the rudder on
the mark.
❏
11. Locate the nylon retaining pin and slide it onto the
wire on the end of the tail wheel assembly.
❏
12. Glue the pin into the hole in the rudder. Cut off the
excess wire from the tail wheel assembly.
Electric Motor / Glow Engine Installation
We are providing instructions for the installation of an
electric motor and ESC as well as the installation of a glow
engine. You should determine which you will be using before
you continue. Though the engine or the motor will mount in
a similar manner, the servos are installed differently for an
electric motor than they are for a glow engine. If you will be
installing a glow engine, skip ahead to " Install the Glow
Engine, Fuel Tank and Throttle Servo Installation" on
page 14.
Electric Motor, ESC & Battery Installation
Note: The recommended components for this installation
can be found at the "Electric Motor and Motor Mount
Recommendations" section of this instruction manual on
page 4.
❏
1. Locate the components of the electric power system
including the motor, two spacers, wheel collar, prop adapter,
mounting screws and the motor mount.
❏
2. Remove the front half of the motor mount and install
the motor to the mount and the prop adapter to the front of
the motor with four 3 x 8mm MS (not included). Be sure to
use a drop of threadlocker on each of the bolts.
13
Advertisement
Table of Contents
