S.bus Quick Start - GREAT PLANES Avistar 30cc ARF Instruction Manual

S.BUS SYSTEM
WING
Your system is not limited to programming only through the
SBC-1 channel changing tool and your transmitter. Utilizing the
USB interface, the CIU-2, you can do all of the programming
using your PC. Programming with this interface gives more
fl exibility and programming options than can be achieved
with any other radio system. To utilize standard, non S.Bus
servos, you simply use the S.Bus decoder instead of the
S.Bus lead.
S.Bus Radio Equipment Recommendations
We will only set-up the wing with the S.Bus System. When
installing the wing on the fuselage, this will reduce the number
of servo leads to be connected to two. The same Futaba
S3305 servos used in the wing for the Basic Set-up can still
be used but will require two S.Bus Decoders.
(1) S.Bus Receiver Futaba R6208SB (FUTL7668
(Works with the FASST-2.4GHz system)
(1) S.Bus channel changer (FUTM4190) Required if
your transmitter does not have an S.Bus Connector
(check your transmitter instruction manual)
The same servos used in the Basic Radio Set-up
and
(2) S.Bus Decoder SBD-1 (FUTM4192)
OR
(4) Futaba S3070HV S.Bus servos (Ailerons
and Flaps replacing four of the S3305 servos)
(FUTM0716)
(2) 6" Servo Extension (FUTM4140) (TACM2700)
(2) 1000mm S.Bus Hub (FUTM4196)
Battery
Hub
Servo
S.Bus Receiver
Hub
Servo Servo
Electric Motor Installation
(1) S.Bus Servo Hub Cable 300mm (FUTM4195)
(1) 16" Servo Extension (FUTM4145)
(1) Y-harness for elevator (TACM2751) or (FUTM4135)
(1) Heavy Duty on/off switch (FUTM4385)
(TACM2760)
(1) Charge Receptacle (ERNM3001)
(1) 3200mAh LiFe Receiver battery (HCAM6446)
Additional Items for Gas Installation
(2) 6" Servo Extension (Throttle and Choke)
(FUTM4140) (TACM2700)
(1) Additional Y-harness for the choke if using a
6-channel receiver
(1) Heavy Duty on/off switch (FUTM4385)
(TACM2760)
(1) 1300mAh LiFe ignition battery (HCAM6411)
Please read the instructions included with each S.Bus
component for warnings and more detailed instructions.
1. If you are using a non S.Bus servo you will need to use
an S.Bus decoder. The decoder has three servo connectors
on it. You are going to use the S.Bus channel changer or
S.Bus Connector on your transmitter to set the channel for
each connector. If using your transmitter, follow the manual
included with the transmitter for programming. If you are
using S.Bus servos, the S.Bus decoder is not required. The
servo can be connected directly into the channel changer.
2. In this example, we are going to program the decoder
connector SX1 to channel 1 for our aileron servo.
5
Hub
Servo

S.BUS QUICK START