4. Install the main wheel.
5. Install the wheel pants.
If the plane is being built as a tail dragger, install the main
landing gear in the forward position. If the plane is being
built as the optional trike gear, skip ahead to Install the
Optional Trike Gear.
6. Install the main landing gear on the fuselage.
Install the Tail Gear
1. Drill a 15/64" [6mm] hole in the bottom of the fuselage.
2. Use 6-minute epoxy to glue the tail gear bearing in
the fuselage.
3. Drill a 5/32" [4mm] hole, 1-1/2" [ 38 mm] aft of the
rudder hinge line.
15