11. Center the rudder and servo arm. Attach a 4-40 solder
clevis to the rudder servo horn. Mark, cut and solder the
clevis on the rudder pushrod following the same procedure
used for the aileron pushrods.
12. Reinstall the rudder pushrod.
13. Install the elevator pushrods following the same
procedure used for the rudder.
Nose Gear Steering
1. Trim and glue the outer pushrod tube.
2. Install the screw-lock pushrod connector on the rudder
servo arm.
3. Cut the 2-56 x 24" (61mm) pushrod.
4. Put a Z-bend in one end of the steering pushrod.
20
(for optional nose gear)