Apply The Decals - GREAT PLANES Avistar 30cc ARF Instruction Manual

3. Position the hatch on the fuselage.
4. Test fit the windscreen on the hatch. Trim as necessary.
5. Mark the outline of the windscreen.
6. Use a T-pin to poke holes along the inside of the outline.
7. Wipe off the marks. Remove the hatch from the fuselage
and glue the windscreen to the hatch with Canopy Glue.

Apply the Decals

1. The decals are die-cut from the factory.
2. Be certain the model is clean and free from oily fi ngerprints
and dust. Prepare a dishpan or small bucket with a mixture
of liquid dish soap and warm water—about 1/2 teaspoon
of soap per gallon of water. Submerse one of the decals in
the solution and peel off the paper backing. NOTE: Even
though the decals have a "sticky-back" and are not the
water transfer type, submersing them in soap & water allows
accurate positioning and reduces air bubbles underneath.
3. Position decal on the model where desired. Holding the
decal down, use a paper towel to wipe most of the water away.
4. Use a piece of soft balsa or something similar to squeegee
remaining water from under the decal. Apply the rest of the
decals the same way.
Please use the box top as a guide for the decal placement.
29