Assemble The Fuse; Install The Tail Gear - GREAT PLANES Eagle 580 Manual

o o 3 . Use the string in the wing to route each servo lead
through the wing . Mount the servos, noting that the servo
arms go toward the trailing edge of the wing .
o o 4 . Mount the control horns and servo arms following the
same steps used with the stab . Mount the ball link to the inner
tapped hole on the aileron servo arms . Cut the 4" [102mm]
control horn bolts down to a length of 2-1/4" [57mm] .
o o 5 . Glue the white nylon anti-rotation dowels in the wing
with epoxy .
o o
6 . Repeat steps 1-5 for the other wing .

ASSEMBLE THE FUSE

Install the Tail Gear

o
1 . Grind flat spots on the tail gear wire for the set
screws . Assemble the tail gear as shown in the photo with
threadlocker . Use three 3mm wheel collars, three 3mm x
5mm phillips head screws and one 3mm x 8mm phillips head
screw to assemble it .
o
2 . Remove the covering for the tail gear mounting bolts .
Attach the tail gear with threadlocker, two 4-40 x 3/4" [19mm]
phillips head screws, two #4 flat washers, and two #4 lock
washers .
o 3 . Attach the tail gear steering arm to the bottom of the
rudder with three #4 x 5/8" [15 .9mm] sheetmetal screws .
9