Safety Information; Table 3-2. Server Dimensions And Values - HP 9000 rp3410 User's & Service Manual

Firmware
Firmware consists of many individually linked binary images that are bound together by a single framework
at run time. Internally, the firmware employs a software database called a device tree to represent the
structure of the hardware platform and to provide a means of associating software elements with hardware
functionality.
The firmware incorporates Boot Console Handler (BCH) which provides an interface between the operating
system and the platform firmware.
The firmware supports the HP-UX 11i version 1 (and higher HP-UX versions that support PA-RISC systems)
operating system through the HP 9000 processor family standards and extensions, and has no operating
system-specific functionality included. The operating system is presented with the same interface to system
firmware, and all features are available to the operating system.
Event IDs for Errors and Events
The server firmware generates event IDs similar to chassis codes for errors, events, and forward progress to
the Integrity Integrated Light-Out Management Processor (iLO MP) through common shared memory. The
Integrity iLO MP interprets and stores event IDs. Reviewing these events helps you diagnose and
troubleshoot problems with the server.
Dimensions and Values
Table 3-2 lists the dimensions and their values of the HP 9000 rp3410 and rp3440 servers.
Table 3-2 Server Dimensions and Values
Dimensions
Rack dimensions (depth x width x height)
Pedestal dimensions (depth x width x height)
Rack weight
Pedestal weight
Pedestal footprint
Rack units

Safety Information

Use care to prevent injury and equipment damage when performing removal and replacement procedures.
Voltages might be present within the server. Many assemblies are sensitive to damage by electrostatic
discharge.
Follow the safety conventions listed below to ensure safe handling of components, to prevent injury, and to
prevent damage to the server:
• When removing or installing any server component, follow the instructions provided in this guide.
• If installing a hot-swappable or hot-pluggable component when power is applied (fans are running),
reinstall the server cover immediately to prevent overheating.
Chapter 3
26.8 in (67.9 cm) max x 19.0 in (48.3 cm) x 3.4 in (8.6 cm)
26.6 in (67.5 cm) x 11.6 in (29.5 cm) x 19.5 in (49.4 cm)
Minimum: 38.6 lbs (17.5 kg)
Maximum: 49.0 lbs (22.2 kg)
Minimum: 49.4 lbs (22.4 kg)
Maximum: 56.3 lbs (25.5 kg)
2.1 sq ft (0.2 m2)
2U
Installing the System
Values
Introduction
59