Figure 6-48 Power Module Shims - HP 9000 rp3410 User's & Service Manual

Removing and Replacing Components
Removing and Replacing a Dual Processor Module
Step 10. If you are installing a second dual processor module in a server which contained only one dual
processor module, remove the spacers from the power module mounting: (Figure 6-48.)
a. Locate the two power module shims on the system board.
b. Remove the holding screws that hold the shims in place.
c. Remove the spacers from the holding screws. Discard the spacers.
d. Retain the screws for use when installing the power module.

Figure 6-48 Power Module Shims

Screws
Spacers
194
Shims
Chapter 6