Figure 3-29 Routing The Turbofan Power Cables Through Heatsink Posts - HP 9000 rp3410 User's & Service Manual

Replacing the Processor Airflow Guide
Step 1. Replace the front portion of the airflow guide:
a. Align the release latch of the front half of the airflow guide over the release latch post and snap
it in place.
b. Connect the power connector on the front portion of the guide to the connector on the system
board.
Step 2. Insert system fans 1A and 1B into their mounting positions.
Step 3. Route the processor turbo fan power cables through the processor heatsink posts so that the cables
will not be pinched between the heatsink posts and the processor airflow guide (Figure 3-29).
CAUTION

Figure 3-29 Routing the Turbofan Power Cables through Heatsink Posts

Step 4. Replace the main portion of the airflow guide:
a. Hold the opening on top of the processor airflow guide.
b. At the same time, grasp the back end of the airflow guide and insert the airflow guide into the
server.
c. Connect the power module cable.
d. Place the power and IDE cables in the cable clips.
e. Insert the two airflow guide retaining tabs into the two slots on the front half of the airflow
guide.
f. Replace the memory airflow guide. "Replacing the Memory Airflow Guide" on page 80
Step 5. Replace the server cover.
Chapter 3
Turbo fan power cables can be damaged if pinched between the heatsink posts and
the processor airflow guide. Ensure that the cables are below the top surface of the
heatsink posts before installing the processor airflow guide.
Installing the System
Installing Additional Components
83