Table of Contents
Advertisement
Expansion connector board
For a list of available expansion connector boards, see
An expansion board can be installed near the back of the system board that provides an additional connector
on the rear I/O panel. The board is secured with two screws and connects to the a connector on the system
board.
To remove the expansion connector board:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
In models with a hard drive, remove the hard drive
on page
4.
Remove the two Phillips screws (1) that secure the board to the system board.
5.
Lift to disengage the board from the system board connector, and then remove the expansion connector
board from the computer (2).
To install the expansion connector board, reverse the removal procedures.
30
Chapter 4 Removal and replacement procedures
(Access panel on page
23.
Computer major components on page
(Preparation for disassembly on page
17).
(Hard drive on page
4.
16).
21) and drive cage
Drive cage
Advertisement
Table of Contents
