Additional Items Required - Seagull Models Piper Comanche MS:142 Assembly Manual

KIT CONTEN.TS
SEA14201 Fuselage
SEA14202 Wing Set
SEA14203 Tail Set
SEA14204 Cowling
SEA14205 Main Gear
SEA14206 Nose Gear
SEA14207 Canopy
SEA14208 Decals
SEA14209 Pushrod Set
SEA14210 Wing Tube
SEA14211 Hardware Set

ADDITIONAL ITEMS REQUIRED.

0.61 - 0.75
0.91 - 1.00
Computer radio with 7 servos.
Glow plug to suit engine.
Propeller to suit engine.
Protective foam rubber for radio
system.
Silicone fuel line.
TOOLS & SUPPLIES NEEDED.
Thick cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder's triangle.
Wire cutters.
Masking tape & T-pins.
Thread-lock.
Paper towels.
www.seagullmodels.com
Note:
the wing panels. Note the position of the hinges.
2-stroke.
4-stroke.
and flap and place a T-pin in the center of each
hinge. Slide each hinge into the aileron until
the T-pin is snug against the aileron. This will
help ensure an equal amount of hinge is on
either side of the hinge line when the flap is
mounted to the wing panel.
there is only a slight gap. The hinge is now
centered on the wing panel and flap. Remove
the T-pins and snug the flap against the wing
panel. A gap of 1/64" or less should be
maintained between the wing panel and flap.
HINGING THE FLAP .
The control surfaces, including the
ailerons, elevators, and rudder, are
prehinged with hinges installed, but
the hinges are not glued in place. It
is imperative that you properly
adhere the hinges in place per the
steps that follow using a high-quality
thin C/A glue.
1) Carefully remove the flap from one of
2) Remove each hinge from the wing panel
T-pin.
Hinge.
3) Slide the flap on the wing panel until
3